Hello! Here comes the instruction for programming via VXDIAG VCX NANO for Land Rover and
Jaguar.
Jaguar.
NOTE:
Security system needs to do programming
online with the account password.
online with the account password.
Other systems do not need programming
online.
online.
An external voltage regulator is needed for
the vehicle to make its voltage meet the prompted demands.
the vehicle to make its voltage meet the prompted demands.
Please be strict with programming according
to the software.
to the software.
Video guide in Chinese:
Detailed instruction in English:
Open the SDD interface via Internet. Click “service
function”.
function”.
Click “Suggestion” after data collecting.
Select “Configure the new module. – the
rear differential control module”
rear differential control module”
Click the “Agree” button.
Turn on the ignition switch (Position 2)
according to the instruction on the screen. Then click the tick button to go
on.
according to the instruction on the screen. Then click the tick button to go
on.
Make sure that your vehicle voltage is more
than 12.50V; otherwise the SDD cannot be used.
than 12.50V; otherwise the SDD cannot be used.
Make sure the connected battery charger is
recognized.
recognized.
Then click the tick button to go on, or to
exit if the above demands cannot be met.
exit if the above demands cannot be met.
Turn on the ignition switch (Position
0).Then click the tick button to go on.
0).Then click the tick button to go on.
Turn on the ignition switch (Position
2).Then click the tick button to go on.
2).Then click the tick button to go on.
Click the tick button.
Click the click button.
Click the NotificationChevron button.
Click the tick button.
Turn on the ignition switch (Position
0).Then click the tick button to go on.
0).Then click the tick button to go on.
Click the tick button to continue.
Turn on the ignition switch (Position
2).Then click the tick button to go on.
2).Then click the tick button to go on.
Click the tick button to continue.
Click the tick button.
Turn on the ignition switch (Position
0).Then click the tick button to go on.
0).Then click the tick button to go on.
Turn on the ignition switch (Position
2).Then click the tick button to go on.
2).Then click the tick button to go on.
Click the tick button to clear all the
fault codes.
fault codes.
Click the tick button to continue.
Turn on the ignition switch (Position
0).Then click the tick button to go on.
0).Then click the tick button to go on.
Click the tick button.
Turn on the ignition switch (Position
2).Then click the tick button to go on.
2).Then click the tick button to go on.
Click the tick button to finish control
module procedure.
module procedure.
Turn on the ignition switch (Position 0).Then
click the tick button to go on.
click the tick button to go on.
END.