Problem before entering:
I am trying to change mileage on Volvo V50 2004 dash with digiprog 3 odometer master clone v4.94.
I have downloaded a German version user manual and soldered 3 wires as shown in German manual (checked pin numbers). Adapter 51 has 4 wires.
Pin 25 (white on original, or orange on clone) left unsoldered. I’m getting
“ERROR INIT” message on screen. Processor is MC9S12DG128B. I selected HCS12 in digiprog 3.
Pin 25 (white on original, or orange on clone) left unsoldered. I’m getting
“ERROR INIT” message on screen. Processor is MC9S12DG128B. I selected HCS12 in digiprog 3.
What I’m doing wrong? Then I contacted my dealer.
The obdtool.co.uk technician helped solve the trouble. It should work for whom
has DP3 on this dash.
The obdtool.co.uk technician helped solve the trouble. It should work for whom
has DP3 on this dash.
I checked the Volvo V50 HCS12
user manual with digiprogiii again, and noticed that at least 4 wires,
vss, vdd, tx and rx should be soldered.
user manual with digiprogiii again, and noticed that at least 4 wires,
vss, vdd, tx and rx should be soldered.
I posted the attachment
they provided.
they provided.
VOLVO V50 TACHO
1. Remove and disassemble tachometer.
2. Connect as shown in the photo above the plug 51 with
themarked soldering points. 3. PICTURES on the following page
themarked soldering points. 3. PICTURES on the following page
4. Select the program: cars / trucks –> VOLVO –> V50 HCS12.
5. The DIGIPROG displays the old / wrong Mileage.
6. Program and completed the new / correct Mileage.
NOTE: Pin-signal= end of white wire in first picture
The job needs good soldering/
desoldering skill. Lucky, the problem was settled.
desoldering skill. Lucky, the problem was settled.